Cooling Your Computer With Liquid

Started by {FWE}Ontime-Adm, July 24, 2010, 06:31:43 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

{FWE}Ontime-Adm

Cooling your CPU/Chip Set with liquid is a bit more expensive but with the power house systems of today it is almost a must if you want to keep your systems running cool.

Whether you're using a desktop or laptop  computer, there's a good chance that if you stop what you're doing and listen carefully, you'll hear the whirring of a small fan. If your computer has a high-end video card and lots of processing power, you might even hear more than one.
In most computers, fans do a pretty good job of keeping electronic components cool. But for people who want to use high-end hardware or coax their PCs into running faster, a fan might not have enough power for the job. If a computer generates too much heat, liquid cooling, also known as water cooling, can be a better solution. It might seem a little counterintuitive to put liquids near delicate electronic equipment, but cooling with water is far more efficient than cooling with air.
A liquid-cooling system for a PC works a lot like the cooling system of a car. Both take advantage of a basic principle of thermodynamics - that heat moves from warmer objects to cooler objects. As the cooler object gets warmer, the warmer object gets cooler. You can experience this principle firsthand by putting your hand flat on a cool spot on your desk for several seconds. When you lift your hand, your palm will be a little cooler, and the spot where your hand was will be a little warmer.
Liquid cooling is a very common process. A car's cooling system circulates water, usually mixed with antifreeze, through the engine. Hot surfaces in the engine warm the water, cooling themselves off in the process.
The water circulates from the engine to the radiator, a system of fins and tubes with a lot of exterior surface area. Heat moves from the hot water to the radiator, causing the water to cool off. The cool water then heads back to the engine. At the same time, a fan moves air over the outside of the radiator. The radiator warms the air, cooling itself off at the same time. In this way, the engine's heat moves out of the cooling system and into the surrounding air. Without the radiator's surfaces making contact with the air and dispelling the heat, the system would just move the heat around instead of getting rid of it.
A car engine generates heat as a byproduct of burning fuel. Computer components, on the other hand, generate heat as a byproduct of moving electrons around. A computer's microchips are full of electrical transistors, which are basically electrical switches that are either on or off. As transistors change their states between on and off, electricity moves around in the microchip. The more transistors a chip contains and the faster they change states, the hotter the chip gets. Like a car engine, if the chip gets too hot, it will fail.

Heat Sinks vs. Liquid Cooling

Most computers dispel heat with heat sinks and fans. Heat sinks are basically pieces of metal that provide lots of surface area for the air to touch. The chip warms the heat sink, the heat sink warms the air, and the fan moves the warm air out of the PC case.
This system works most of the time, but sometimes, electronic components produce more heat than simple air circulation can dispel. High-end chips with lots of transistors can overwhelm an air-cooling system. So can chips that have been overclocked, or manually set to work at faster than their default speed.
That's where water cooling comes in. Water has a higher thermal conductivity than air - it can move heat faster than air can. Water also has a higher specific heat capacity. It can absorb more heat before it starts to feel hot.

There are two reasons why a computer might need the increased thermal conductivity and heat capacity of water:

    * Its electronic components produce more heat than the air around them can absorb
    * The fans required to move enough air to cool all the components make too much noise or use too much electricity

In other words, there are two reasons why you might need to cool a computer with a liquid instead of air:

    * The components inside your computer need more cooling than air alone can provide
    * You want your system to be quieter